Skip to content
- Description
- Technical Information
- Printers
Description
Technical filament from polyamide modified for 3D-printing in FFF.
- Filament for FFF-printers with major PA 6 content
- unfilled
- high tensile strength; moderate water absorption
- low warping effect
- excellent adhesion to various print plates
- very smooth surfaces possible (bone white color)
Material Properties
Material shows nearly similar strength for injection-molded or printed parts by the good layer adhesion with highly reduced warping behaviour.
Recommended for all high strength parts with good heat- and media resistance.
The material can be used as a baseline for comparison of the fiber addition impact or where fibers or conductivity is not wanted in the printed part.
The material differs from PA PureLite by less heat absorption in the melting process and a lightly increased moisture sensitivity.
Technical Information
Mechanical properties
| Density | g/ cm³ | 1,2 |
| Modulus of Elasticity printed specimen | MPa (N/mm²) | 3400 |
| Tensile strength printed specimen x-y (+ 45°/-45°) | MPa (N/mm²) | 80 |
| Tensile strength printed specimen x-y (0°) | MPa (N/mm²) | 80 |
| Tensile strength printed specimen x-y (90°) | MPa (N/mm²) | 30 |
| Tensile stress printed specimen x-y (0°) | MPa (N/mm²) | 77,31 |
| Elongation printed specimen (0°) | % | 3,56 |
| Flexural modulus printed specimen (+ 45°/-45°) | GPa (kN/mm²) | 2,37 |
| Impact strength printed specimen x-y (+ 45°/-45°)(Charpy) | kJ/m² | -- |
| Shore hardness | --- | -- |
Thermal properties
| Glass transition temp. | °C | 72 |
| Heat distortion temp.(HDT) | °C | 90 |
Data Sheets
Printers
The Material has been tested on following printers:
| Printer | F3 PA-CF Pro | F3 PA-GF Pro | F3 PA Pure Pro | F3 PA-CF Lite | F3 PA Pure Pro |
| 3NTR A2/A4 | x | x | x | x | x |
| Evo-Tech Evolizer EL-102 | x | x | x | x | x |
| Hage3D 84L/140L | x | x | x | x | x |
| Multec M500/M800 | x | x | x | x | x |
| Prusa I3 MK3S | x | x | x | ||
| Raise3D N2/N2+ (Bondtech-upgrade) | x | x | x | x | x |
| Raise3D Pro2/Pro2+ | x | x | x | ||
| Ultimaker S5/S3 | x | x | x | x | x |
| Zortrax M200 Plus | x | x |
