This is the Ultimaker Glass Plate. With it you no longer need the blue tape. It gives you a high quality gloss bottom surface and great adhesion. This part is NOT...

Power supply for Ultimaker 3D Printers

The Bowden tube, 67cm long. Made from PFA. Outside diameter 0.25 inches, inside 0.125 inches is used to transport the filament to the extruder head. Includes a Clamp Clip and...

The belts are used for taking the drive from the motor to the printhead. Timing Belt B300 MXL for Ultimaker Original Series

This is the Ultimaker 2 hot end bundle. This bundle is ONLY compatible for the Ultimaker 2, Ultimaker 2 Go and Ultimaker 2 Extended and contains: The integrated nozzle +...

Summary The hot end bundle is fool proof when assembling. There is only one way to assemble it, no (more) small differences. It is leak free, So no need to...

Summary This is the Ultimaker 2 and Ultimaker Original+ print table heated bed. This is the Ultimaker 2 and the Ultimaker Original+ print table heated bed. The heated bed allows...

This is the Ultimaker 2 integrated nozzle + heater block for 3mm filament. This part is also included in the Ultimaker 2 hot end bundle. It has a 0.4mm diameter....

This is the Ultimaker 2 hot end isolator. It is the connection between the PTFE coupler and the nozzle + heater block. It is also included in the Ultimaker 2...

Heated Bed Cable for the Ultimaker Original+

This part is also included in the Hot End v2 bundle. This part is compatible with the complete Ultimaker Original and Ultimaker Original+.

Summary This part is also included in the Hot End v2 bundle. This part is compatible with the complete Ultimaker Original and Ultimaker Original+.

Summary This is an injection moulded, glass filled PEEK part, made to our specification to be used for a hybrid material extruder. It is made so that you can insert...

Summary Used to power the motors. Includes 1 stepper driver. This part is compatible with the complete Ultimaker Original

Summary The thermocouple sensor is used to read the temperature of the hot end. It's connected to the Thermocouple transmitter. This part is compatible with the complete Ultimaker Original.

Summary The Thermocouple transmitter is being used to send the collect and temperature data to the electronics. It's placed on top of your print head. This part is compatible with...