Our New 3D Printing Service is Now Available!Go to 3D AMPS
£82.80 inc VAT
£69.00 exc VAT

Technical filament from polyamide modified for 3D-printing in FFF.

  • Filament for FFF-printers with major PA 6 content
  • 15 weight-% glass fiber
  • high tensile strength; moderate water absorption
  • low warping effect
  • excellent adhesion to various...

Call our expert advisors to get a tailored solution on 01257 228411 or add this product for a personalised quote

Technical filament from polyamide modified for 3D-printing in FFF.

  • Filament for FFF-printers with major PA 6 content
  • 15 weight-% glass fiber
  • high tensile strength; moderate water absorption
  • low warping effect
  • excellent adhesion to various print plates
  • bone white surface finish

Material Properties

The glass fibers reduce the shrinkage and the warping behaviour extremely. Material shows excellent strength with remaining impact resistance.

Recommended for all high strength parts with good heat- and media resistance.

Printed parts show a rough matte surface finish.

The material differs from F3 PA-CF Pro in lower tensile strength. The fibers are not electricallly conductive and therefore an alternative for carbon fibers .

The high stiffness of the filament should be considered for the pipes and the feeder system of the printer to avoid breaking.

Mechanical properties

Density g/ cm³ 1,27
Modulus of Elasticity printed specimen MPa (N/mm²) 5560
Tensile strength printed specimen x-y (+ 45°/-45°) MPa (N/mm²) 80
Tensile strength printed specimen x-y (0°) MPa (N/mm²) 90
Tensile strength printed specimen x-y (90°) MPa (N/mm²) 40
Tensile stress printed specimen x-y (0°) MPa (N/mm²) 89,68
Elongation printed specimen (0°) % 1,98
Flexural modulus printed specimen (+ 45°/-45°) GPa (kN/mm²) 3,08
Impact strength printed specimen x-y (+ 45°/-45°)(Charpy) kJ/m² --
Shore hardness --- --

Thermal properties

Glass transition temp. °C 65
Heat distortion temp.(HDT) °C 90

Data Sheets

Download Technical Data Sheet

Download Safety Data Sheet

The Material has been tested on following printers:

Printer F3 PA-CF Pro F3 PA-GF Pro F3 PA Pure Pro F3 PA-CF Lite F3 PA Pure Pro
3NTR A2/A4 x x x x x
Evo-Tech Evolizer EL-102 x x x x x
Hage3D 84L/140L x x x x x
Multec M500/M800 x x x x x
Prusa I3 MK3S x x x
Raise3D N2/N2+ (Bondtech-upgrade) x x x x x
Raise3D Pro2/Pro2+ x x x
Ultimaker S5/S3 x x x x x
Zortrax M200 Plus x x
Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page