UltiMaker 2 Extended+

The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...

The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...

The JET RSB have a revised tip angle, revised jet shoulder width and revised internal geometry, with a gentle slope leading down to the exit. They are also slippery inside,...

The JET RSS50 is meant for printing abrasive materials, and such much stronger than a brass nozzle. The downside is slower printing speed due to the lower thermal conductivity of...

Each pack contains 5 of the same size Ultimaker 2+ nozzles The nozzle sizes available are: 0.25 mm 0.4 mm 0.6 mm 0.8 mm Ensure continuous printing with a handy set of...

Each pack contains 5 of the same size Ultimaker 2+ nozzles The nozzle sizes available are: 0.25 mm 0.4 mm 0.6 mm 0.8 mm Ensure continuous printing with a handy set of...

Each pack contains 5 of the same size Ultimaker 2+ nozzles The nozzle sizes available are: 0.25 mm 0.4 mm 0.6 mm 0.8 mm Ensure continuous printing with a handy set of...

Each pack contains 5 of the same size Ultimaker 2+ nozzles The nozzle sizes available are: 0.25 mm 0.4 mm 0.6 mm 0.8 mm Ensure continuous printing with a handy set of...

ONE NOZZLE FOR ALL MATERIALS The Olsson Ruby will work with a huge range of materials. PLA, ABS, CPE/PET, Nylon, and composites with abrasive additives such as Carbon fibre, Steel,...

ONE NOZZLE FOR ALL MATERIALS The Olsson Ruby will work with a huge range of materials. PLA, ABS, CPE/PET, Nylon, and composites with abrasive additives such as Carbon fibre, Steel,...

ONE NOZZLE FOR ALL MATERIALS The Olsson Ruby will work with a huge range of materials. PLA, ABS, CPE/PET, Nylon, and composites with abrasive additives such as Carbon fibre, Steel,...

ONE NOZZLE FOR ALL MATERIALS The Olsson Ruby will work with a huge range of materials. PLA, ABS, CPE/PET, Nylon, and composites with abrasive additives such as Carbon fibre, Steel,...

ONE NOZZLE FOR ALL MATERIALS The Olsson Ruby will work with a huge range of materials. PLA, ABS, CPE/PET, Nylon, and composites with abrasive additives such as Carbon fibre, Steel,...

Everything you need to get started 3D printing Silicone - from start to finish, no guesswork required. Features 870mL of our Preferred air-cure Silicone 35x Sheets of Premium (Extra Thick)...