All

A pack of twenty-five adhesion sheets to ensure consistent, high-quality results by achieving an optimal print surface and excellent adhesion of your 3D printer to the build plate. How to...

A pack of twenty-five adhesion sheets to ensure consistent, high-quality results by achieving an optimal print surface and excellent adhesion of your 3D printer to the build plate.

Available for the Ultimaker 3D Printers  Ultimaker's Advanced 3D Printing Kit has been designed to help you get consistent, reliable print results every time. Special adhesion sheets included in the...

Part of the Hot End Also included in the Hot End v2 bundle. Only compatible with the Ultimaker Original and Original +

The Arduino Mega 2560 is a microcontroller board based on the ATmega2560 (datasheet). It contains everything needed to support the microcontroller; simply connect it to a computer with a USB...

Axial Fan 35 x 35 x 10

Replacement Bowden Tube with collets and clips, used to transport filament to the extruder head. Bowden tube is made from PFA. Compatible with Ultimaker S5 3D printers.

The Bowden tube, 67cm long. Made from PFA. Outside diameter 0.25 inches, inside 0.125 inches is used to transport the filament to the extruder head. Includes a Clamp Clip and...

Summary Fan Pack v1 This part is compatible with the complete Ultimaker Original. Features Electronics Cooling Fan - 24VDC Fan Duct Electronics Fan Duct Print Head Print Head Fan -...

Glue stick

Heated Bed Cable for the Ultimaker Original+

The heater cartridge is being used to heat your hot end. Ultimaker 2 24V 25W

The heater cartridge is being used to heat your hot end.   Ultimaker 2 Extended  24V 25W

The heater cartridge is being used to heat your hot end. Ultimaker 2 Go  24V 25W